DCS RDT-366SS Guia de Instalação

RGS SERIES RANGEInstallation GuideMODELS:RGS-305RGS-366RGS-364GLRGS-364GDRGS-484GGRGS-486GLRGS-486GDRGS-485GD

INSTALLING ANTI - TIP DEVICE9All ranges must have an anti-tip devicecorrectly installed as per the followinginstructions. If you pull the range outfro

CABINET PREPARATION10STEP 4:1) The range is a free standing unit. If the unit is to be placed adjacent to cabinets, the clearances shown in fig. 8 (RG

CABINET PREPARATION110” ClearanceCJI0” ClearanceBAFCHEDG36" Min. toCombustibles12" Min. toCombustibleswithout backguardFig. 9 RGS 48” &

CABINET PREPARATION120” ClearanceBAFCHEDG0” ClearanceCJ I36" Min. toCombustibles12" Min. toCombustibleswithout backguardMin. 30"

BACKGUARD KITS:The backguard is located as shown in Fig. 12.Secure the backguard to the wall behind therange. Specific instructions for installation o

ELECTRICAL / GAS CONNECTIONS14GAS REQUIREMENTSVerify the type of gas supplied to the location. Therange are shipped from the factory set up and adjust

STEP 6:CAUTION:For Warranty coverage, DCS requires that burner adjustments be made by a qualified technician at the time of installation. Extreme care

INSTALLER FINAL CHECKLIST16GENERAL Placement of unit. Specified clearance maintained to cabinet surfaces. Unit Level - front to back, side to side.

RGS-48 WIRING DIAGRAM17

RGS-36 WIRING DIAGRAM18

1Thank you for selecting this DCS RGS Gas Range. Because of this appliance’s unique features we havedeveloped this Installation Guide. It contains val

RGS-48/36 SCHEMATIC19

RGS-485 WIRING DIAGRAM20

RGS-485 SCHEMATIC21

RGS-305 WIRING DIAGRAM22

RGS-305 SCHEMATIC23

HOW TO OBTAIN SERVICE24For warranty service, contact DCS Customer Service at (888) 281-5698. Before you call, please havethe following information rea

WARRANTY25Length of Warranty:One (1) Year Full parts and Labor Covers the entire product.Five (5) Year Surface burners, oven burner.Ten (10) Year Porc

NOTES26

NOTES27

NOTES28

TABLE OF CONTENTS2INTRODUCTION...

5800 Skylab Road, Huntington Beach, CA 92647 Tel: 714.372.7000 • Fax: 714.372.7001 Customer Service: (888) 281-5698 www.dcsappliances.comAs

INTRODUCTION3The DCS Professional series ranges are designed with a large number of features available in amultitude of different combinations. Top bu

MODELS448” RGS RANGE MODELSRGS-484GG36” RGS RANGE MODELSRGS-36630” RGS RANGE MODELSRGS-305OVEN ONHEATINGDOOR LOCKEDHEATINGRGS-486GL RGS-486GDRGS-485GD

PLANNING THE INSTALLATION5RECOMMENDED INSTALLATION INSTRUCTIONInstall components in the following order:A) Vent HoodB) Backguard SystemC) Range1) Loca

UNPACKING AND HANDLING6CAUTION:Proper equipment and adequate manpower must be used in moving the rangeto avoid damage to the unit or the floor. The un

UNPACKING AND HANDLING7After checking the countertops for level andbefore sliding the range into place, measure thedistance from the floor to the top

VENTILATION REQUIREMENTS8STEP 2:A suitable exhaust hood must be installed above the range. The following chart indicates theminimum blower capacity re